Текст страницы
EN EN Connecting with Dreamehome App
Before Use
2. Add Device
1. Download the Dreamehome App
1. Place the Charging Dock and Connect to an
Electrical Outlet
3. Install the Side Brush
Scan the QR code on the robot, or search "Dreamehome" in the app store to
download and install the app.
Open the Dreamehome app, tap "
" in the upper right corner, and scan the
same QR code on the robot again to add the device. Please follow the prompts
to finish the Wi-Fi connection.
Side Brush
Place the charging dock on level ground against the wall. Insert the power cord
into the charging dock and plug it into the socket.
Click
Place the charging dock in a location that is as open as possible with a good
Wi-Fi signal.
Side Brush Clip
＞ 0.5 m
Wi-Fi Indicator
·Blinking slowly: To be connected
·Blinking quickly: Connecting
·On: Connected
＞ 1.5 m
＞ 0.5 m
Note:
QR Code
Note: Install the side brush until it clicks into place.
· Remove any objects that are closer than 1.5 m from the front and 0.5 m from
either side of the charging dock.
· Do not place the charging dock in an area with direct sunlight or where other
objects might block the signal, as this may hinder the robot from returning to
the charging dock.
4. Charge the Robot
2. Remove the Protections
Note:
When placing the robot, align the charging contacts at the bottom of the robot
with the charging contacts of the charging dock, and the robot will automatically
turn on and start charging.
Note: If you want to reset Wi-Fi, repeat step 2 and then follow the prompts
to finish the Wi-Fi connection.
·Only 2.4 GHz Wi-Fi is supported.
·Due to upgrades in the app software, the actual operations may differ from
the directions in this manual. Please follow the instructions based on the
current app version.
Note: It is recommended to fully charge your robot before first time use.
10
11