Текст страницы
EN
EN
Routine Maintenance
Routine Maintenance
Dust Box
Filter
Parts
To keep the robot in good condition, it is recommended to refer to the accessory usage in the app or the following table for routine maintenance.
1. Open the robot's cover and press the clip to remove the dust box.
1. Remove the filter and tap its basket gently.
Part
Maintenance
Frequency
Replacement Period
Part
Maintenance
Frequency
Replacement Period
Mop pad
After each use
Every 3 to 6 months
Bumper
Main brush
Every 6 to 12 months
Once every month
/
Bottom of the robot
Once every 2 weeks
Cliff sensors
Dust box's filter
Every 3 to 6 months
Side brush
Return-to-Base Sensor
Charging dock's
signaling area
Note: Do not attempt to clean the filter with a brush, a finger or sharp objects
to prevent damage.
Water tank
Clean it as needed
/
Dust box
Charging dock's
charging contacts
Omnidirectional wheel
Once every month
/
2. Rinse the dust box and filter with clean water and dry them completely before
reinstalling.
2. Open the dust box cover and empty the dust box as shown in the diagram.
Note: The replacement frequency will depend on your usage of the robot.
If an exception occurs due to special circumstances, the parts should be
replaced.
Laser Distance
Sensor (LDS)
12
1
11
2
10
3
9
24 hrs
4
8
5
7
6
Robot's charging
contacts
Note:
· Rinse the dust box and filter with clean water only. Do not use any detergent.
· Use the dust box and filter only when they are completely dry.
14
15