Текст страницы
EN
EN
How to Use
How to Use
Auto Resume Cleaning
Use Mopping Function
3. Align the mopping module as indicated by the arrow, then slide it into
the back of the robot until it clicks into place. Press the button
or use
Dreamehome app to start cleaning.
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning eff ect.
If the battery is too low, the robot will automatically return to the charging
dock to charge. After charging to the appropriate battery level, it will resume
unfinished cleaning tasks.
Note: To use this function, please open it in the App.
Turn On/Off
Press and hold the button
for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the charging dock, the
robot should turn on automatically and begin charging. To turn off the robot,
move the robot away from the dock and press and hold the
button for 3
seconds.
1. Dampen the mop pad and wring out excess water. Install the mop pad as
shown in the diagram.
Do Not Disturb (DND) Mode
Fast Mapping
Click
When the robot is set to Do Not Disturb (DND) mode, the robot will be prevented
from resuming cleaning and the power indicator will turn off . DND mode is
disabled by default at the factory. You can use the app to enable DND mode or
modify the DND period. The DND period is 22:00–8:00 by default.
After configuring the network for the first time, follow the instructions in the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the charging dock, the mapping process has been
completed and the map will be saved automatically.
Click
Note:
· The scheduled cleaning tasks will be performed as usual during the DND period.
· The robot will resume cleanup where it left off after the DND period expires.
Note:
Spot Cleaning
• It is not recommended to use the mopping function on carpets.
①
②
③
Start Cleaning
Press the button
to start cleaning after the robot is turned on. Then, the
robot will accurately map out a route, methodically clean along the edges
and walls, then finish by cleaning each room in an S-shaped pattern to
ensure a thorough job.
• Use the app to adjust the water flow as required.
2. Fill up the tank with water.
Note: It is recommended that the robot set out from the charging dock
before cleaning. Do not move the charging dock while the robot is cleaning.
This ensures that the robot returns to charging dock smoothly.
When the robot is on standby, press and hold the button
for 3 seconds to
enable the spot cleaning mode. In this mode, the robot cleans a square-shaped
area of 1.5 × 1.5 meters around it and returns to its starting point once the spot
cleaning is completed.
4. When the robot finishes a cleaning task and returns to the charging dock,
remove the mopping module and wash the mop pad in time. To remove the
water tank, slide the two release clips on the side of it to take it out.
Pause/Sleep
Robot Restarting
When the robot is running, press any button to pause it.
If the robot stops responding or cannot be turned off , press and hold the button
for 10 seconds to forcefully turn it off . Then, press and hold the button
for 3
seconds to turn the robot on.
If the robot is paused for more than 10 minutes, it automatically enters
sleep mode. All indicators on the robot will turn off . Press any button on the
robot, or use the app to wake up the robot.
Note: If the robot is paused and placed onto the charging dock, the current
cleaning task will end.
Note:
• Do not use detergent or disinfectant.
• Do not fill the water tank with hot water as this may cause the water tank to warp.
Note: When the robot is charging or not in use, remove the mopping
module, pour out all the remaining water in the water tank, and clean the
mop pad to prevent mildew or odors.
12
13