Текст страницы
EN
EN
How to Use
Routine Maintenance
Use Mopping Function
Parts
To keep the robot in good condition, it is recommended to refer to the accessory usage in the app or the following table for routine maintenance.
3. Align the mopping module as indicated by the arrow, then slide it into
the back of the robot until it clicks into place. Press the power button or use
Dreamehome app to start cleaning.
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning effect.
Part
Maintenance
Frequency
Replacement Period
Part
Maintenance
Frequency
Replacement Period
1. Dampen the mop pad and wring out excess water. Install the mop pad as
shown in the diagram.
Mop pad
After each use
Every 3 to 6 months
Bumper
Main brush
Every 6 to 12 months
Click
Once every month
/
Bottom of the robot
Dust box's filter
Once every 2 weeks
Cliff sensors
Every 3 to 6 months
Side brush
Return-to-Base Sensor
Click
Water tank
Charging dock's
signaling area
Note:
Clean it as needed
/
Dust box
• It is not recommended to use the mopping function on carpets.
①
②
③
Once every month
/
Charging contacts
• Use the app to adjust the water flow as required.
Omnidirectional wheel
2. Fill up the tank with water.
Note: The replacement frequency will depend on your usage of the robot.
If an exception occurs due to special circumstances, the parts should be
replaced.
Laser Distance
Sensor (LDS)
4. When the robot finishes a cleaning task and returns to the charging dock,
remove the mopping module and wash the mop pad in time. To remove the
water tank, slide the two release clips on the side of it to take it out.
Note:
• Do not use detergent or disinfectant.
• Do not fill the water tank with hot water as this may cause the water tank to warp.
Note: When the robot is charging or not in use, remove the mopping
module, pour out all the remaining water in the water tank, and clean the
mop pad to prevent mildew or odors.
13
14