Текст страницы
EN
EN
Routine Maintenance
Routine Maintenance
Dust Box
Filter
Mopping Module
3. Clean the mop pad with water only and leave it to air dry before reinstalling.
1. Open the robot's cover and press the clip to remove the dust box.
1. Remove the filter and tap its basket gently.
1. Slide the two release clips on the side of the water tank, remove the
mopping module, and pull the mop pad off the mopping module.
12
1
11
2
10
3
9
24 hrs
4
8
5
7
6
Note: Do not attempt to clean the filter with a brush, a finger or sharp objects
to prevent damage.
Note: Remove the mop pad from the mopping module before cleaning it, and
make sure dirty water does not flow back into the water outlet to avoid clogging.
2. Rinse the dust box and filter with clean water and dry them completely before
reinstalling.
2. Open the dust box cover and empty the dust box as shown in the diagram.
2. Pour out the water in the tank. Clean the tank with water only and leave
it to air dry before reinstalling.
4. If slow water flow occurs, or the water volume is not well-distributed, clean
the air hole in the cover of the water tank.
12
1
11
2
10
3
9
24 hrs
4
8
5
7
6
Note:
Note: Do not directly expose the water tank to sunlight.
· Rinse the dust box and filter with clean water only. Do not use any detergent.
· Use the dust box and filter only when they are completely dry.
15
16