Текст страницы
EN
EN
Routine Maintenance
Routine Maintenance
Side Brush
Main Brush
Robot Sensors
Charging Contacts and Signaling Area
Clean the charging contacts and the signaling area with a soft and dry cloth.
Remove and clean the side brush.
1. Press the brush guard clips inwards to remove the brush guard and lift
the brush out of the robot.
Wipe robot sensors by using a soft and dry cloth, as shown in the below
figure:
Laser Distance
Sensor (LDS)
Return-to-Base Sensor
Omnidirectional Wheel
Bumper
Cliff Sensors
Battery
2. Pull out the brush covers at both ends of the brush as shown in the
diagram. Use the provided cleaning tool to remove any hair tangled in
the brush. Reinstall the brush covers on both ends of the brush, and then
reinstall the brush. Press on the brush guard to lock it in place.
The robot contains a high-performance lithium-ion battery pack. Make sure
that the battery remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of
time, turn it off and put it away. To prevent damages from over-discharging,
charge the robot at least once every three months.
Note:
Note : A wet cloth can damage sensitive elements within the robot and the
charging dock. Please use a dry cloth for cleaning.
· Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
· Rinse the omnidirectional wheel under the running water and put it back after
drying it completely.
17
18