Текст страницы
EN EN Routine Maintenance
Routine Maintenance
Main Brush
Used Water Tank
Mop Pad Holder
Robot Sensors
1. Remove the used water tank, open its cover and pour out the used water.
Remove and clean the mop pad holder.
Wipe robot sensors by using a soft and dry cloth, as shown in the below figure:
1. Press the brush guard clips inwards to remove the brush guard and lift the
brush out of the robot.
3D Line Laser Sensor
Laser Distance
Sensor (LDS)
Bumper
2. Rinse the used water tank with clean water, and use a proper cleaning
tool to clean the inner wall of the used water tank.
2. Pull out the brush covers at both ends of the brush as shown in the figure.
Use a proper cleaning tool to remove any hair tangled in the brush. Reinstall
the brush covers on both ends of the brush, and then reinstall the brush.
Press on the brush guard to lock it in place.
Edge Sensor
Omnidirectional Wheel
Cliff Sensors
Carpet Sensor
Note: The float ball in the used water tank is a movable part. Do not apply too much
force when cleaning it to avoid damaging it.
Side Brush
Remove and clean the side brush.
Note:
· Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
· Rinse the omnidirectional wheel under the running water and put it back
Note: A wet cloth can damage sensitive elements within the robot and the
base station. Please use a dry cloth for cleaning.
after drying it completely.
14
15