Текст страницы
EN EN How to Use
Routine Maintenance
4. Clean the used water tank
Vacuum and Mop
Parts
To keep the robot in good condition, it is recommended to refer to the accessory usage in the app or the following table for routine maintenance.
After the robot has completed its task, please clean the used water tank to
prevent any odor.
Note: When using the mop assembly for the first time, the robot performs the
"Vacuum and Mop" task by default.
1. Start cleaning
Part
Maintenance Frequency
Replacement Period
Mop after Vacuuming
Part
Maintenance Frequency
Replacement Period
Used water tank
After each use
Carpet sensor
Press the power button on the robot, or use the app to make the robot start
from the base station. Then the robot will plan the optimal cleaning route
and perform the cleaning task based on the created map.
/
Clean water tank
Cliff sensors
Enable the mopping after vacuuming function in the app, and the robot will
automatically lift the mop assembly to vacuum the floor. After vacuuming
is completed, the robot will return to empty the dust box, and then start
mopping after automatically lowering the mop assembly.
Note:
Main brush
Every 6 to 12 months
Once every month
· To ensure the robot easily returns to the base station after cleaning, it is
Bumper
/
recommended to make the robot start from the base station.
Once every 2 weeks
Dust box's filter
· The mop pads will be cleaned before the robot starts mopping, please wait
Every 3 to 6 months
Side brush
Bottom of the robot
Vacuum Only
patiently.
Mop pad holder
/
· Do not move the base station, the clean water tank, the used water tank, or
Dust box
Clean it as needed
Enable the vacuuming function in the app, and the robot will automatically lift
the mop assembly and start vacuuming.
the washboard during operation.
Washboard
Dust bag
Every 2 to 4 months
2. Auto mop washing
/
Base station's
signaling area
Mop pad
Every 1 to 3 months
Mop Only
Charging contacts
When cleaning, the robot will automatically return to the base station to wash
mop pads based on the mop pad cleaning frequency specified in the app.
The base station will automatically refill the robot's water tank and the robot
will resume cleanup.
Auto-empty vents
Enable the mopping function in the app, and the robot will check if the mop
assembly is installed. If not, manually install the mop assembly, and then the
robot will automatically start mopping.
Once every month
/
Note: The replacement frequency will depend on your usage of the robot.
If an exception occurs due to special circumstances, the parts should be
replaced.
3. Automatically empty the dust box and wash and dry the mop
pads
Omnidirectional
wheel
Edge sensor
After the robot finishes a cleaning task and returns to the base station to
charge, the base station will automatically start emptying the dust box. Then
it will wash and dry the mop pads.
Laser distance
sensor (LDS)
Note:
· If the auto-empty function is turned off in the app, the base station will not
automatically empty the dust box.
3D line laser
sensor
· The base station will empty the dust box according to the setting in the app.
10
11