Текст страницы
EN
EN
Before Use
Before Use
- Remove Robot Protections and Install the Mop Assembly
- Connect the Robot to the Base Station
5. Add the Cleaning Solution
6. Add Water to the Clean Water Tank
Take out the clean water tank from the base station and fill up the
tank with clean water. Then install it back into the base station.
Press and hold the button on the robot for 3 seconds to turn it
on. Place the robot onto the base station with the mop assembly
facing toward the washboard. Then you will hear a voice notification
when the robot successfully connects to the base station. After the
robot is fully charged, the status indicators on the robot and the
base station will remain lit for 10 minutes and then dim.
（1）Remove the dust tank cover and pull out the auto-detergent
compartment.
（2）Open the upper lid of the compartment and add the cleaning
solution.
（3）Close the lid of the compartment, put it back into the base
station, and then reinstall the dust tank cover. The cleaning solution
will be added automatically while working.
③
①
②
②
①
②
①
Note:
Note: Do not add hot water into the water tank, as this may cause the tank to
become deformed.
Note: It is recommended to fully charge the robot before its first use. When
the robot cannot be turned on after the battery is depleted, manually connect
the robot with the station to charge it.
· The auto-detergent compartment can be filled up with cleaning solution
for use. Do not add any liquid other than the officially-approved cleaning
solution to help prevent malfunction.
· Install the auto-detergent compartment until it clicks into place.
13
14