Текст страницы
Fault
Cause
Rectification
The cleaning robot does
not start
Ambient temperature is below 0 °C or
above 35 °C.
1. Use the cleaning robot at temperatures
above 0 °C and below 35 °C.
Charging state is too low.
1. Charge the cleaning robot.
Laser distance sensor (LiDAR) is
blocked.
1. Clean the laser distance sensor with a dry
cloth.
2. Remove obstacles blocking the laser dis-
tance sensor.
3. Move the cleaning robot to another location
and start it.
Collision sensor is dirty or too close to the
virtual wall.
1. Remove foreign objects by carefully tap-
ping on the collision sensor.
2. Move the cleaning robot to another location
and start it.
Fall sensors are dirty.
1. Clean the fall sensors with a dry cloth.
The water reservoir or dust container is
not installed or incorrectly installed.
1. Ensure the water reservoir or the dust con-
tainer is installed and correctly latched into
place, see chapter Installing the water res-
ervoir or. Installing the dust container
Filter not installed or incorrectly installed. 1. Make sure that the filter is correctly in-
stalled.
Filters dirty.
1. Clean the filter, see chapter Cleaning the
filter.
2. If the error persists, replace the filter, see
chapter Replacing the filter.
Wiper cloth or wiper cloth holder not or in-
correctly installed.
1. Ensure that the wiper cloth and wiper cloth
holder are correctly installed, see chapter
Installing the wiper cloth or Installing the
wiper cloth holder.
The cleaning robot is jammed or stuck.
1. Remove obstacles.
The cleaning robot or one of its wheels
has no floor contact.
1. Place the cleaning robot on a flat surface.
The cleaning robot is not connected to
the network or is not within the range of
the WLAN signal.
The cleaning robot can-
not connect to
the WLAN/The cleaning
robot goes offline
1. Make sure that the cleaning robot is con-
nected to the network and is within the
range of the WLAN signal.
2. Make sure that the WLAN password is cor-
rect.
3. Reset the WLAN and connect again (5
GHz WLAN networks are not supported).
The WLAN signal is too weak.
1. Make sure that the cleaning robot is within
range of the WLAN signal.
Disposal
Further warranty information (if available) can be found
in the service area of your local Kärcher website under
"Downloads".
WARNING
Technical data
Electrical connection
This device contains Lithium-Ion rechargea-
ble batteries. The removal and proper dis-
posal of lithium-ion batteries must be
carried out in accordance with national and
state regulations.
Nominal power
W
36
Nominal voltage of battery
V
14,4
Battery pack type
Li-ION
Nominal voltage of charger
V
100-240
Rated current charger
A
0,8
Battery capacity
mAh
4800
Warranty
The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing flaw is the cause. In a warranty case, please con-
tact your dealer (with the purchase receipt) or the next
authorised customer service site.
(See overleaf for the address)
Rechargeable battery nominal ca-
pacity
mAh
5200
Operating time when battery is ful-
ly charged in normal operation
min
120
24
English