Текст страницы
Installing the Hardware
Replacing the Bracket
The AT-2701 series adapter card is shipped with the low-profile bracket
attached to the adapter. Depending on your system, you may need to
replace the bracket attached to your adapter card.
The following procedure describes how to remove the low-profile bracket
from the adapter card and replace it with the standard bracket. You can
also use this procedure to remove the standard bracket and replace it with
the low-profile bracket.
To replace the low-profile bracket with the standard bracket, perform the
following procedure:
1.
Remove the screws that attach the bracket to the adapter card. See
Figure 6.
Figure 6. Removing the Low-Profile Bracket
2.
Align the tabs of the standard bracket with the holes on the adapter
card and fasten the screws onto the adapter card. See Figure 7 on
page 27.
26