Текст страницы
en Troubleshooting
2. Start the Spin . programme.
Easy Iron is activated.
Fault
Cause and troubleshooting
The laundry is too wet
after the spinning
cycle.
Set a suitable programme.
Page 21
Creasing.
The selected programme is unsuitable for the type of
fabric.
Set a suitable programme.
Page 21
A high spin speed is selected.
The next time you run a wash cycle, set a lower spin
speed.
The load is unsuitable.
Observe the programme's maximum load capacity.
Page 21
Prepare the laundry.
Page 25
Water is leaking out at
the water inlet hose.
The water inlet hose is not correctly connected or is
damaged.
Check the installation of the water inlet hose.
Page 10
Replace the water inlet hose if it is damaged.
Water is leaking out at
the water outlet hose.
The water outlet hose is not connected correctly or is
damaged.
Check the installation of the water outlet hose.
Dirt on the door or seal causes leaks.
Page 10
Replace the water outlet hose if it is damaged.
Water is leaking from
below the door.
There is too much detergent or fabric softener in the
detergent drawer.
When dosing, observe the marking in the detergent
drawer.
Page 27
Clean the door and the seal.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Insert in compartment is blocked.
Clean the detergent drawer.
Page 32
Residual water is
present in the com-
partment .
The use of fabric softener is not supported for the se-
lected programme.
Fabric softener re-
mains in the detergent
drawer.
Check whether the use of fabric softener is suppor-
ted for the selected programme.
Page 21
Odours have formed
in the appliance.
Humidity and detergent residue may promote the form-
ation of bacteria.
Clean the drum.
Page 31
40