Текст страницы
5. Press down on each corner of the washer top to make sure the washer doesn’t
«wobble». There should be no «give» or movement. All the washer feet should
press equally against the floor. This is just as important as the washer being
level to prevent vibration.
6. When the washer is level and does not wobble, lock the washer feet in place by
tightening the locknuts against the washer bottom. Be sure to do this without
changing the height of the foot (hold the foot while tightening the locknut).
Procedure for adjusting the appliance feet
1. After determining which the washer feet need to be extended, have someone lift
up on the washer slightly to take pressure off the foot to be adjusted.
2. Turn the washer foot to extend it downward as far as necessary to raise the
corner of the washer the correct amount to level the washer.
3. When the height of the foot is correct, use the wrench (supplied) to tighten the
locknut against the washer bottom. The locknut should be tighten against the
bottom of the washer to lock the foot in place.
60