Текст страницы
CONNECTION THE ELECTRICITY AND WATER SUPPLIES
Connecting the water inlet hose
1. Connect one end of the water inlet hose to
a cold water tap and tighten by hand (see figure).
Before performing the connection, allow the
water to run freely until it is perfectly clear.
2. Connect the other end of the water inlet
hose to the water inlet valve on the rear of the
appliance and tighten by hand.
3. Turn on the tap slowly and make sure there
are no leaks.
Do not twist, squash, modify or cut the hose.
Tighten the end of the hose firmly by hand.
The supply water pressure must be in the 0.03-
1.0 MPa range. If the water pressure exceeds
this value, please fit a pressure reducing valve.
If the hose is not long enough, contact a
specialized shop or an authorized technician.
Never use second-hand water inlet hose.
Use the new water inlet hose supplied with the washer.
Connecting the drain hose
Height of drain point
Height difference between the floor and drainage point: min. 60 cm (24 in.) and
max. 100 cm (39 in.).
61
www.hiberg.ru