Текст страницы
AUTOMATIC WASHING MACHINE
Machine might be standing
unbalanced
Adjust the feet to level the machine
A hard substance might have
entered into the pump filter
Clean the pump filter.
Transportation safety bolts
are not removed.
Remove the transportation safety bolts
Machine vibrates or
makes noise.
Laundry quantity in the
machine might be too little.
Add more laundry to the machine.
Machine might be
overloaded with laundry
Take out some of the laundry from the machine
or distribute the load by hand to
balance it homogenously in the machine.
It will resume running when the voltage restores
to the normal level.
Machine stopped
shortly after the
programme started.
Machine might have stopped
temporarily due to low
voltage
Timer may stop during water
intake
Timer indicator will not countdown until the
machine takes in adequate amount of water.
The machine will wait until there is sufficient
amount of water to avoid poor washing results
due to lack of water. Timer indicator will resume
countdown after this.
Programme time does
not countdown.
Timer may stop during
heating step.
Timer indicator will not countdown until the
machine reaches the selected temperature.
Timer may stop during
spinning step.
Automatic unbalanced load detection system
might be activated due to the unbalanced
distribution of the laundry in the drum.
Use recommended amount of detergent
Laundry remains
wet at the end of the
programme
Excessive foam might have
occurred and automatic foam
absorption system might
have been activated due to
too much detergent usage.
ATTENTION! Troubleshooting that is not spelled out in this manual can only
be carried out by a qualified specialist.
In case of malfunctions that are not specified in this manual, you should immediately
contact an authorized service center, specifying the type of problem and the model of
your washing machine. Only original spare parts can be used for repairs. Unqualified
repair removes the device from warranty service.
43
USER GUIDE