Текст страницы
СТИРАЛЬНАЯ МАШИНА АВТОМАТ
СТИРАЛЬНАЯ МАШИНА АВТОМАТ
AUTOMATIC WASHING MACHINE
AUTOMATIC WASHING MACHINE
damages.
CAUTION
UNPACKING THE WASHING MACHINE
• Unpacking your washing machine and check if is there any damage during the transportation.
Also make sure that all the items in the attached bag are received. If there is any damage to the
washing machine during the transportation, or any item is missing or damaged, please contact
the local dealer immediately.
• If your washing machine is not double inlet, you do not have the hot inlet hose.
Installation and connection
Remove transit bolts
Before using this washing
machine, transit bolts
must be removed from the
backside of this machine.
Please take the following
steps to remove the bolts:
• Don’t use the appliance as a stand for any heavy objects.
• Don’t move the appliance by the door, it is not designed for the weight of the appliance
and may break.
• Make sure that the laying of water pipes and electric wires has no danger to stumble
people.
• Failure to observe this safety instruction may result in damage to the instrument, burns,
injury, electric shock, short circuit or fire.
• Any repair or regulation that may be necessary must be carried out with the greatest
care and attention. Always call an authorized Technical Assistance Center if repairs
are required, specifying the type of problem and the model of your appliance. Repairs
made by incompetent persons could cause damage.
• Only original spare parts use for appliance repair.
• Our company cannot be held responsible for the damages to people, animals or
properties due to improper use and security breaches.
Part names and accessories
- Loosen all bolts with spanner and then remove them.
- Stop the holes with transport hole plugs.
- Keep the transport bolts properly for future use.
Door
Component
Select the location
Detergent
dispense
Power supply cord
Drum
Water inlet valve
Drain hose
Before installing the washing machine, the location characterized as follows shall be selected:
• Rigid, dry, and level surface (if not level, please make it level with reference to the following figure
“Adjust Leg”)
• Avoid direct sunlight
• Sufficient ventilation
• Room temperature is above 0 C
• Keep far away from the heat resources such as coal or gas.
• Make sure that the washing machine will not stand on power cord.
• Do not install the washing machine on the carpet floor.
Adjust Legs
1. When positioning the washing machine, please first check if the legs are closely attached to the
cabinet. If not, please turn them to their original positions with hand or spanner and tighten the
nuts with spanner.
2. After positioning the washing machine, press four corners on top cover of washing machine in
sequence. If the washing machine is not stable when being pressed, this leg shall be adjusted.
3. Ensure the positioning status of washing machine. Loosen the lock nut with spanner and turn the
Service filter
leg with hand until it closely contacts with the floor. Press the leg with one hand and fasten the
nut closely to the cabinet with the other hand.
4. After being locked properly, press four corners again to make sure that they has been adjusted
Accessories
properly. If it is still unstable, it has to repeat Steps 2 and 3.
5. Put a solid cylinder (e.g. pop cans) oppositely on the top cover of the washing machine from
in the left, right, front and back directions. If the cylinder keeps stable, the washing machine is
positioned level. If it rolls, the washing machine is positioned unlevel. The rolling direction is the
direction of lower ground surface. Then, the two legs in this direction shall be raised at the same
time until the washing machine is level. Steps 1~3 are repeated to make the bottom legs closely
I
Instruction
nlet pipe
Transport
plug
hole
36
37
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE