Текст страницы
Installation procedures:
MIG / MAG installation:
1.
Turn off the welding machine.
2.
Connect the gas bottle (A) behind the machine by the gas pipe.
3.
Connect the dinse connector of the earth clamp (B) to the negative "-"
4.
Insert the MIG torch connector (D) into the centralized euro socket (euro connector) (E) and tighten the ring nut.
5.
Open the side panel and insert the wire into the machine compartment, then insert the coil into the reel holder and tighten.
6.
Insert the wire in the trolling-wire making it adhere to the groove of the roller (ATTENTION: the roller has two grooves: by turning the roller
you can choose the appropriate groove according to the diameter of the wire to be used). When the diameter of the wire is changed it is
necessary to change both the roller and the contact tip (the end part of the torch from which the thread is seen to come out).
7.
Unscrew the end of the torch (nozzle) and the contact tip to facilitate the passage of the wire.
8.
Close the door. Turn on the welding machine.
9.
Set the machine for the MIG function,
10. Press the torch button until the thread comes out of it.
GAS CONNECTION
NO GAS CONNECTION
11