Инструкция сварочный аппарат CAT DZ 261 PFC MIG

Setting of welding current and voltage

1) Press the ENTER key to enter the welding interface shown below:

2) In the welding interface, rotate L Knob to set the welding current, for which the adjustable

scope is different with the welding wires and gases as described in §4.3;

3) The welding voltage will be automatically set as the value corresponding to that of the welding
current set by rotating L Knob.
4) When the programmed welding current does not meet user requirements, the setting is
available by rotating R Knob;

5) After the setting, press L Knob and R Knob for confirmation;

Operation of the MIG/MAG Manual welding method:

1. Selection of the welding method:

1) In the main interface, press the MENU key to enter the function selection interface;

2) In the function selection interface, rotate L Knob to select the MIG/MAG Manual welding

method and press down it for confirmation as shown in Fig. 1;
3) Spool Gun Switch turn off(down).

1. Selection and setting of welding parameters:
2. In the main interface, press the MENU key to enter the welding parameter setting interface;

2) In the welding parameter setting interface, rotate L Knob to select the parameter as required

and rotate R Knob to set a value for the parameter, afterwards, press L Knob or R Knob for

confirmation. Refer to Fig. 2;
3. Setting of wire feed rate and welding current:
1) Press the ENTER key to enter the welding interface shown below:

2) In the welding interface, rotate L Knob to set the wire feed rate (1.5 - 13.0 m/min) and rotate R
Knob to set the welding current (10 - 27 V);
3) After the settings, press L Knob and R Knob for confirmation;
4) Spool Gun turn on (up):

13