Текст страницы
IM2021
ATTENTION!
If a large amount of condensate is generated on the upper part of the appliance when it
is operating, then you need to decrease the steam outlet intensity by turning on/off and
steam outlet intensity knob counterclockwise.
Automatic switching off when there is no water
When water level in the tank drops below minimal level, the ultrasonic membrane will
automatically switch off and the red indicator will light up on the control panel. To
continue operation of the appliance it is necessary to fill the tank with water according
to «Filling the water tank» paragraph, and then connect the appliance to the electric
mains.
Switching off
To switch the appliance off, turn on/off and steam outlet intensity knob all the way to
the left and disconnect the appliance from the electric mains.
9. CLEANING AND MAINTENANCE
•
Before cleaning the appliance, make sure it is unplugged. Otherwise, it may result
in electric shock.
•
Before cleaning, in order not to burn your hands, wait until the water in the base of
the appliance has completely cooled.
•
Use a damp and soft cloth to wipe the outside of the appliance.
•
To avoid electric shock, do not scratch or damage the components of the device
when cleaning.
•
Do not use solvent, gasoline, dimethylbenzene, hard brush, talcum powder and
other substances when cleaning the device.
•
Wipe off any remaining water inside the base of the unit under the tank with a
damp and soft cloth.
•
To remove water on small parts, you can use a brush and then wipe them again
with a soft cloth.
•
Clean the device once or twice a week.
•
If dirt is formed on the membrane, clean it with a brush.
•
Rinse the water tank cover and nozzle carefully and effortlessly with fresh water,
otherwise this will cause water to leak through the cover.
•
After removing any remaining water from the surface of nozzle, wipe it with a soft
cloth.
•
Clean the outside of the appliance with a damp and soft cloth.
IMPORTANT!
•
To avoid deformation of working surfaces, resulting in decreased atomizing or
other malfunctions, do not use metallic brushes, blades or talc powder to wipe the
atomizer’s surface.
•
The water tank may leak after heavy impacts.
•
In case of water leakage, immediately stop using the unit and contact an
authorized service center.
19