Текст страницы
IM2021
•
To keep the unit dry, wipe the water after cleaning and dry the unit’s base and
water tank. Make sure that there is no water left inside the unit’s base and water
tank.
•
Before a long break in use, dry the base and the tank, but the tank on the base and
pack the device in a plastic bag, then put it in a box.
•
Store the unit in a low-humidity room.
•
Storing the unit undried results in generation of mold.
To clean the water tank and parts of the base of the device from salt deposits, use
citric acid:
•
for 1 liter of hot water, take 1 tablespoon of citric acid and mix well;
•
pour the solution into the tank and put it on the base of the humidifier (water from
the tank will automatically fall into the base of the device);
•
leave the humidifier for 10-12 hours - do not turn it on;
•
after the time has passed, remove the solution from the device along with the
exfoliated parts of the salt coating;
•
if it is difficult to remove plaque - use a special brush for the base of the humidifier
(if this is not supplied, you can use a toothbrush). For the tank - pour 0.5-1 cups of
dry rice into cold water or a cooled citric acid solution and shake until the plaque is
peeled off;
•
rinse all internal parts of the device with cool water;
•
use a humidifier as usual after the procedure.
10. TROUBLESHOOTING
Malfunction
Possible cause
Solution
The unit is operating in
the low atomizing mode
(low
atomizing frequency)
It is not a malfunction.
Switch the device into the
intensive mode of
operation
The atomizer is clogged
Clean the atomizer.
Poor atomizing (insufficient
productivity)
Temperature of water in
the
tank is low
Set maximum productivity
mode. The humidifier’s
productivity will go up after
a while.
No atomizing
The power cord is poorly
connected to the outlet
Connect the power cord
into
the outlet carefully
White patches have
formed on the membrane
Use filtered water
There is white patches
from the water on objects
around the humidifier
(salts, separating out from
water)
Clean the humidifier’s
membrane with a special
brush
There is a lot of salts in the
water (calcium and
magnesium)
Steam has a bad smell
Stale water is used
Clean the unit according to
the cleaning and servicing
instructions and fill the tank
Remains of stale water or
waste have accumulated in
20