Текст страницы
en Avoiding material damage
The light emitted by LED lights is very
dazzling, and can damage the eyes (risk
group 1).
▶Do not look directly into the switched-on
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric
shock.
▶Before cleaning, pull out the mains plug or
switch off the fuse in the fuse box.
▶Do not use steam- or high-pressure clean-
LED lights for longer than 100 seconds.
Improper repairs are dangerous.
▶Repairs to the appliance should only be
carried out by trained specialist staff.
▶If the appliance is defective, call Customer
ers to clean the appliance.
Penetrating moisture may cause an electric
shock.
▶Do not use wet sponge cloths.
Service.
→ "Customer Service", Page 9
WARNING ‒ Danger: Magnetism!
The appliance contains permanent magnets.
They may affect electronic implants, e.g.
pacemakers or insulin pumps.
▶Persons with electronic implants must
WARNING ‒ Risk of explosion!
Highly caustic alkaline or highly acidic clean-
ing agents in conjunction with aluminium parts
in the interior of the appliance may cause ex-
plosions.
▶Never use highly caustic alkaline or highly
stand at least 10 cm away from the appli-
ance.
acidic cleaning agents. In particular, do not
use commercial or industrial cleaning
agents in conjunction with aluminium parts,
e.g. grease filter on extractor hoods.
Avoiding material damage 2 Avoiding material damage
ATTENTION!
Condensate may cause corrosion damage.
▶
To prevent condensation from building up, switch on
the appliance during cooking.
If moisture gets into the controls, this may result in
damage.
▶
Never clean controls with a wet cloth.
Incorrect cleaning damages the surfaces.
▶
Follow the cleaning instructions.
▶
Do not use harsh or abrasive detergents.
▶
Clean stainless steel surfaces in the direction of the
finish only.
▶
Never clean controls with stainless steel cleaners.
Condensation that flows back in may damage the ap-
pliance.
▶
To prevent condensate from returning, fit the ex-
haust air pipe with a 1° gradient from the appliance.
If you put incorrect stress on the design elements, they
may break off.
▶
Do not pull design elements.
▶
Do not place objects on the design elements or
hang objects from them.
There is a risk of surface damage if you do not peel off
the protective film.
▶
Remove the protective film from all parts of the ap-
pliance before using for the first time.
Painted surfaces are easily damaged.
▶
Follow the cleaning instructions.
→ "Cleaning the appliance", Page 7
▶
Ensure that the painted surfaces are not scratched.
Environmental protection and saving energy 3 Environmental protection and saving energy
3.1 Disposing of packaging
Adjust the fan speed to the amount of steam pro-
duced during cooking.
¡ The lower the fan speed, the less energy is con-
The packaging materials are environmentally compat-
ible and can be recycled.
▶
Sort the individual components by type and dispose
of them separately.
sumed.
Only use the intensive mode as required.
If cooking produces large amounts of steam, select a
higher fan speed in good time.
3.2 Saving energy
¡ The odours are distributed around the room less.
Switch off the lighting if it is no longer required.
If you follow these instructions, your appliance will use
less power.
¡ When the lighting is switched off, it does not con-
sume any energy.
4