Текст страницы
www.aeg.com
22
Problem
Possible cause
Remedy
The fuse is blown.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
You do not set the heat set-
ting for 60 seconds.
Activate the hob again and
set the heat setting in less
than 60 seconds.
Touch only one sensor field.
You touched 2 or more sen-
sor fields at the same time.
Pause operates.
Refer to "Daily use".
The display does not react
to the touch.
Part of the display is covered
or the pots are placed too
near to the display.
There is some liquid or an
object on the display.
Remove the objects. Move
the pots away from the dis-
play.
Clean the display, wait until
the appliance is cold. Dis-
connect the hob from the
electrical supply. After 1 min,
connect the hob again.
You put something on one
or more sensor fields.
Remove the object from the
sensor fields.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
You put something on the
Remove the object from the
sensor field.
sensor field
.
Residual heat indicator does
not come on.
The zone is not hot because
it operated only for a short
time or the sensor under the
hob surface is damaged.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
You cannot activate the
highest heat setting.
Another zone is already set
to the highest heat setting.
First reduce the power of the
other zone.
The sensor fields become
hot.
Put large cookware on the
rear zones if possible.
The cookware is too large or
you put it too near to the
controls.
Hob²Hood does not work.
You covered the control pan-
el.
Remove the object from the
control panel.
Hob²Hood operates, but on-
ly the light is on.
You activated the H1 mode.
Change the mode to H2 - H6
or wait until the automatic
mode starts.
Hob²Hood modes H1 - H6
operate, but the light is off.
There might be a problem
with the light bulb.
Contact an Authorised Serv-
ice Centre.