Текст страницы
EN
selected hob zone. >>> Center the hob
zone by choosing a pot that is wide
enough for the hob zone.
RU
KK
The cooling fan continues to run even
though the hob is turned off.
• This is not an error. The cooling fan con-
tinues to operate until the electronic
equipment inside the hob cools to the ap-
propriate temperature.
There is a noise coming from the hob while
cooking
• There may be some noises coming from
the hob during cooking. These noises de-
pend on the composition of the cook-
ware. These noises are normal, not a
malfunction and are part of induction
technology.
Possible sounds and causes:
• Fan noise: The hob has a fan that auto-
matically operates according to the tem-
perature of the product. The fan has dif-
ferent operating levels and operates at
different levels according to the temper-
ature. After the hob is turned off, if the
temperature is high according to the
product temperature, the fan may con-
tinue to operate for a while.
• Low hum like transformer operation:
This is the nature of induction techno-
logy. Since the heat is transferred directly
to the bottom of the cookware, this kind
of hum may occur depending on the ma-
terial of the cookware. Therefore, differ-
ent sounds may be heard with different
cookware.
• Crackling sound: This is due to the ma-
terial and structure of the bottom of the
cookware. If the cookware is made of dif-
ferent materials and layers, crackling
noise may occur.
• Whistling sound: A whistling sound may
be heard when cooking on two hob zones
on the same side of the hob at different
cooking levels.
Error codes/reasons and possible solutions
Error codes
Error reasons
Possible solutions
E 22
Induction hob is overheated.
E 26
Turn the induction hob off and wait
until it is cooled down. The error shall
be resolved when temperature of the
hob comes down below the limits.
E 27
A pot suitable for induction heating is
not used.
The error shall be resolved when a
pot suitable for induction heating is
used.
E 42
Incorrect electrical wiring connection
has been made.
It should be checked whether the
electrical cable connection is made
correctly according to the values
given in the technical table and the
correct connection should be made.
When the correct connection is made,
the error will disappear.
One or more keys are kept pressed
for more than 10 seconds.
The problem shall be resolved when
you remove your hand from the hob.
E 46
An object is left on the control panel
or the control is exposed to vapour.
The problem shall be resolved when
the control panel is cleaned.
E 47
A pot suitable for induction heating is
not used.
The error shall be resolved when a
pot suitable for induction heating is
used.
E 1 – E 15
Communication error on induction
hob.
Turn the induction hob off and oper-
ate again after 30 seconds. Contact
the authorized dealership if the issue
is resumed.
EN / 25