Текст страницы
3 Log in the Switch
Switch to End Node
Use standard Cat.5/5e Ethernet cable (UTP/STP) to connect the Switch to end nodes as described
below. Switch ports will automatically adjust to the characteristics (MDI/MDI-X, speed, duplex) of the
device to which is connected.
Connect PC to switch
Log in to the Switch
As the Switch provides Web-based management login, you can configure your computer’s IP address
manually to log on to the Switch. The default settings of the Switch are shown below.
Table 3-1 Default value
Parameter
Default Value
Default IP address
192.168.1.110
Default user name
admin
Default password
admin123
You can log in the configuration window of the Switch through following steps:
Connect the Switch with the computer NIC interface.
Power on the Switch.
Check whether the IP address of the computer is within this network segment: 192.168.1.xxx
(xxx ranges 0–254, except 110), for example, 192.168.1.100.
Open the browser, and enter http://192.168.1.110 and then press Enter. The Switch login
window appears, as shown below.
Log in the Switch 8