Текст страницы
Configuration example I
Configuration example II
4.3.3 Trunk-port Setting
In the navigation bar, select VLAN config > trunk-port setting, can set port to Trunk port, the
following picture:
Trunk port
[Parameter Description]
Parameter
Description
Native VLAN
Only set one
Allowing VLAN
Can set up multiple
[Instructions]
Native VLAN: as a Trunk, the mouth will belong to a Native VLAN. The so-called Native VLAN, is refers
to UNTAG send or receive a message on the interface, is considered belongs to the VLAN. Obviously,
the interface of the default VLAN ID (PVID) in the IEEE 802.1 Q VLAN ID is the Native VLAN. At the
same time, send belong to Native VLAN frame on the Trunk, must adopt UNTAG way.
Allowed VLAN list: a Trunk can transport the equipment support by default all the VLAN traffic
(1-4094). But, also can by setting the permission VLAN Trunk at the mouth of the list to limit the flow
of some VLAN can't through the Trunk.
[Configuration Example]
Such as: PVID=VLAN2
PC1:192.168.1.122, port 8, access VLAN2
Switch Configuration 24