Текст страницы
• In case of damage, do not put the appliance into
The climate class can be found under "Technical
operation. Contact your distributor.
Data" and on the rating label located in the interior
or on the appliance rear.
NOTE:
• Place the appliance on a steady and safe surface.
Production residue or dust may have collected on the
If the appliance is not horizontally leveled, adjust
appliance. We recommend cleaning the appliance
the feet accordingly.
according to chapter “Cleaning and Maintenance”.
• Avoid the installation:
- near heaters, next to a stove, direct sunlight or
Appliance Equipment
any other heat sources;
- at locations with high humidity (e.g. outdoors,
Appliance overview
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
- Do not expose the appliance any weather.
Leveling the appliance
Slight unevenness in the floor can be leveled out
1 Grid shelves
3 Condensate drip tray
using the front feet.
2 Temperature control
4 Feet
Check whether the appliance is leveled horizontally.
Delivery scope
If the appliance is not in balance, the feet must be
adjusted.
2x grid shelf, 1x ice cube tray, 1x ice scraper,
1x condensate drip tray
Electrical connection
WARNING:
Installation
• The installation to the mains supply must conform
to the local standards and regulations.
Conditions for the installation location
• Improper connection may cause to an electric
• Good ventilation is required around the appliance
shock!
to dissipate the heat properly and to guarantee ef-
• Do not modify the appliance plug. If the plug does
ficient cooling operation at low power consump-
not fit properly to the outlet, let install a proper
tion. Enough clearance is necessary.
outlet by an authorized specialist.
- Gap to the back approx. 50～70 mm, to the
• The accessibility of the power plug must be en-
side walls and above the appliance each ap-
sured to disconnect the appliance from the power
prox. min. 100 mm;
supply in case of emergency.
- Place the appliance so that the appliance door
• Make sure that the voltage supply matches the
can open without being impeded.
specifications on the rating label before connect-
• Only install at a location with an ambient tempera-
ing.
ture suitable for the climate class of the appliance.
19