Текст страницы
EN
EN
How to Use
How to Use
Start Cleaning
Switch Modes
Press
to switch modes based on your needs.
Gently step on the brush cover and recline the appliance backward. Press
to start cleaning.
Press
to switch modes based on your needs.
Turbo Mode
The appliance will vacuum the stubborn stains on the floor.
Smart Mode
The appliance will intelligently adjust the suction power
according to the stains on the ground.
Quiet Mode
The appliance will maintain moderate suction power
and low noise level.
Suction Mode
Sucks up a large amount of water from the floor.
Note:
• Do not vacuum any foamy liquids.
• If the appliance is in the upright position while working, the current task will be suspended.
• The appliance is only suitable for cleaning hard surfaces such as wood floors, marble, and tiles.
Fill the Clean Water Tank
• Please press the brush against the floor when using.
• Do not lift or move the appliance while in operation to prevent dirty water from flowing back
into the motor.
Remove the clean water tank. Open the tank cover and fill the tank with sufficient clean
water. Re-install the tank and ensure it clicks into place.
• Do not add any liquids other than the officially-approved cleaner. The cleaner can be available
on the official online store. Refer to the cleaning solution label for specific usage instructions.
Empty the Used Water Tank
Pull the tank handle to take out the used water tank. Remove the tank cover and pour
out the used water. Re-install the tank and ensure it clicks into place.
1
2
4
3
9
10