Текст страницы
EN
Cleaning and maintenance
● Cleaning the inlet filters
1.Remove the inlet filters.
2.Wash the inlet air filter and the inlet motor safety filter.
Soak the filters in laundry detergent solution for 15 minutes for better
cleaning.
Do not wash filters with hot water. Do not wring filters.
3. If the additional inlet filter is clogged or dirty, wash it.
Soak additional inlet filter in laundry detergent solution for 15 minutes for
better cleaning.
Do not wash the filter with hot water. Do not wring the filter.
.Dry the inlet filters fully in shade so that moisture is entirely removed.
4
.After the filters are completely dry, put them back into the vacuum
5
cleaner. Follow instructions in "Removing the inlet filters" section
It takes at least 12 hours for the filters to dry completely.
Do not dry the inlet filters on the radiator or near heating devices.
CAUTION
● Cleaning the exhaust filters
1. Remove the exhaust filters cover on the body by pulling it out.
2. Separate the exhaust HEPA filter and the exhaust additional filter.
3. Shake off the exhaust HEPA filter. Clean the exhaust HEPA filter with
a soft brush along the folds of the filter. Do not wash it.
4. Wash the exhaust additional filter.
Dry it fully in shade so that moisture is entirely removed.
Do not dry it on the radiator or near heating devices.
5. Put the filters back into the vacuum cleaner. Fit exhaust filters cover
lugs to the grooves of vacuum cleaner body.
Push the exhaust filters cover until it is locked in the position.
NOTICE: Wash the inlet filters at least once a month.
Clean the exhaust filters at least once a year.
If the filter is deformed or damaged, replace it with a new one.
12