Текст страницы
EN
EN
Routine Maintenance
Routine Maintenance
Side Brush
Mopping Module
Main Brush
Remove and clean the side brush.
1. Slide the two release clips on the side of the water tank, remove the
mopping module, and pull the mop pad off the mopping module.
3. Clean the mop pad with water only and leave it to air dry before reinstalling.
1. Press the brush guard clips inwards to remove the brush guard and lift
the brush out of the robot.
12
1
11
2
10
3
9
24 hrs
4
8
5
7
6
Omnidirectional Wheel
Note: Remove the mop pad from the mopping module before cleaning it, and
make sure dirty water does not flow back into the water outlet to avoid clogging.
2. Pull out the brush covers at both ends of the brush as shown in the
diagram. Use the provided cleaning tool to remove any hair tangled in
the brush. Reinstall the brush covers on both ends of the brush, and then
reinstall the brush. Press on the brush guard to lock it in place.
2. Pour out the water in the tank. Clean the tank with water only and leave
it to air dry before reinstalling.
4. If slow water flow occurs, or the water volume is not well-distributed, clean
the air hole in the cover of the water tank.
Note: Do not directly expose the water tank to sunlight.
Note:
· Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
· Rinse the omnidirectional wheel under the running water and put it back after
drying it completely.
16
17