Текст страницы
EN
EN
How to Use
How to Use
1. Turn On/Off
4. Pause/Sleep Mode
7. Use the Mopping Function
Pause: Press any button briefly to pause the robot during cleaning.
3) Align the mopping module as indicated by the arrow, then slide it into
the back of the robot until it clicks into place. Press the button
or use the
Dreamehome App to start cleaning.
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning effect.
Press and hold the button
for 3 seconds to turn on the robot. Once the
power indicator turns solid white, the robot is on standby. To turn off the
robot, press and hold the button
for 3 seconds when the robot is not
moving.
Sleep Mode: If the robot pauses for more than 10 minutes, it automatically
enters the sleep mode, and the power indicator and charging indicator will
go off. To wake up the robot, press any button.
1) Dampen the mop pad and wring out excess water. Insert the mop pad into
the slot of the water tank as shown in the figure, and paste the pad firmly.
Note:
2. Start Cleaning
Click
· The robot will turn off automatically if left in Sleep Mode for more than 12 hours.
· If the robot is paused and placed onto the base, the current cleaning task will
end.
Press the button
briefly to turn on the robot. Upon activation, the robot
will accurately map out a route, methodically clean along the edges and
walls, then finish by cleaning each room in an S-shaped pattern to ensure
a thorough job.
Click
5. Spot Clean Mode
①
②
③
Note:
• It is not recommended to use the mopping function on carpets.
• Use the app to adjust the water flow as required.
When the robot is paused or in Standby Mode, press and hold the button
for
3 seconds to start Spot Clean Mode. In this mode, it will clean a square-shaped
area of 1.5×1.5 meters directly around the robot. When the spot cleaning is
done, the robot will automatically return to its original location and power off.
4) Press the two side clips inwards and slide the water tank backwards to
separate it from the robot.
2) Open the water tank lid, fill the tank with water, then securely close the lid.
Note: Activating Spot Clean Mode will end the current cleaning task of the robot.
6. Additional App Functions
Follow the instructions on the app interface to use more functions. The version
of the app might have been updated; please follow the instructions based on
the current app version.
3. Cleaning Mode
Dreame Bot D9 Plus has four cleaning modes: Quiet, Standard, Strong, and
Turbo. The default mode is Standard. You can specify the cleaning mode in
the Dreamehome App.
Note: Do not use detergent or disinfectant.
Note: When the robot is charging or not in use, remove the mopping module,
pour out all the remaining water in the tank, and clean the mop pad to prevent
mildew or odors.
10
11