Текст страницы
EN
EN
Routine Maintenance
Routine Maintenance
Clean the Dust Bin
* Clean after each use
Clean the Mopping Module
3. Clean the mop pad with water only and leave to air dry before re-installing.
3. Clean the dust intake.
1. Press the two release clips on the side of the water tank, remove the
mopping module, and pull the mop pad off the mopping module.
1. Open the robot cover, then press the dust
bin clip to remove the dust bin.
2. Open the bin cover and empty the
bin as shown in the diagram.
12
1
11
2
10
3
9
24 hrs
4
8
5
7
6
Note:
• Remove the pad from the mopping module before cleaning it, and make sure
dirty water does not flow back into the water outlet to avoid clogging.
Clean the Filter
• For optimal performance, it is recommended to replace the mop pad every 3-6
months.
- Do not wash the filter. Only the dust bin is washable. Thoroughly dry it before re-installing.
- Remove the filter and tap its basket gently.
12
1
11
2
10
3
9
24 hrs
2. Pour out the water in the tank. Clean with only water and leave out to air
dry before re-installing.
4. If slow water flow occurs, or the volume is not well-distributed, clean the air
hole in the cover of the water tank.
4
8
5
7
6
Note:
· Do not attempt to clean the filter with brushes or fingers.
· Rinse the dust bin with clean water only. Do not use any detergent.
· Use the dust bin and filter when they are completely dry.
Note: Do not expose the tank to the sun directly.
· The filter is recommended to be cleaned every two weeks and replaced every three months.
12
13