Текст страницы
EN
EN
Routine Maintenance
Routine Maintenance
Dust Box and Filter
Charging Contacts and Signaling Area
Robot Sensors
3. Gently tap the basket of the filter to remove the dirt.
Clean the charging contacts and the signaling area with a soft and
dry cloth.
1. Open the robot cover and press the dust box clip to remove the
dust box.
Wipe the robot sensors by using a soft and dry cloth, as shown in
the below figure:
3D Dual-Line Laser
Sensors
Bumper Window
Laser Distance
Sensor (LDS)
Note: Do not attempt to clean the filter with a brush, a finger or sharp objects
to prevent damage.
Edge Sensor
Bumper
2. Remove the dust box filter, and then empty the dust box.
Auto-Empty Vents
4. Rinse the dust box and filter with water and dry them completely
before reinstalling.
Cliff Sensors
24h
Clean the auto-empty vents of the robot and the base station with a
soft and dry cloth.
Carpet Sensor
Note:
·Rinse the dust box and filter with clean water only. Do not use any detergent.
·Use the dust box and filter only when they are completely dry.
Note: A wet cloth can damage sensitive elements within the robot and the
base station. Please use a dry cloth for cleaning.
25
26