Текст страницы
Document version: V1.2
10.8.3 WAN parameters
When the Ethernet cable is intact and connected to the WAN port properly, but No Ethernet cable
is connected to the WAN port is still shown on the Internet Settings page, you can try to change
the Speed to 10 Mbps full duplex or 10 Mbps half duplex to solve the problem. Otherwise, keep
the default settings.
To access the configuration page, log in to the web UI of the router, and navigate to More >
Network Settings > WAN Parameters.
The following table describes the parameters displayed on this page.
Parameter description
Speed
Application
1000 M Auto-
negotiation
Indicates that the speed and duplex mode are determined through the negotiation
with the peer port.
100 Mbps full duplex
Indicates that the WAN port is working at the speed of 100 Mbps, and the port can
receive and send data packets at the same time.
100 Mbps half
duplex
Indicates that the WAN port is working at the speed of 100 Mbps, but the port can
only receive or send data packets alternately.
10 Mbps full duplex
Indicates that the WAN port is working at the speed of 10 Mbps, and the port can
receive and send data packets at the same time.
10 Mbps half duplex
Indicates that the WAN port is working at the speed of 10 Mbps, but the port can only
receive or send data packets alternately.
96