Текст страницы
Non-POE power supply-wire sequence diagram
4. Tighten the back cover to the camera housing, adjust the length of cable, and then tighten the
waterproof lock to the marked position. (Note: Please keep the back cover aligned with the scale on
the camera housing during the adjustment of waterproof lock).
5. Fasten the camera housing to the bracket and tighten the top screw. Loosen the bracket adjusting
nut on the camera bracket, adjust the camera angle, and tighten it after adjusting the picture to the
required scene. Remove the protective film from the housing and complete the installation.
Note: The mounting surface of camera must have sufficient bearing capacity.
3.2.3. HD Network IR Dome Camera
(Unit: mm)
Installation Diagram of HD Network IR Dome Camera-V2.0
25