Инструкция IP-камера Tiandy TC-C32KS I3/E/Y/C/SD/2.8mm/V4.2

2. Mark the mounting hole position of camera on the wall with a ink pen, make holes on the

indicated hole position with a electric drill, and drive the expansion rubber plug into the hole that has

just been made.

3. Fasten the chassis on the wall with screws. Reassemble the components removed in Step 1. Adjust

the direction of camera to a suitable position, and tighten the 3 mounting screws on the housing of

V2.0 equipment. Rotate the component of V3.0/V4.0/V5.0 equipment into the snap position and then

fasten it.

Note: The mounting surface of camera must have sufficient bearing capacity.

3.2.4. HD Network IR Dome Camera (MINI)

Installation Diagram of HD Network IR Dome Camera (MINI)

Steps:

1. Mark the positions of holes for mounting camera on the wall using an ink pen.

2. Make holes at the indicated position with an electric drill, and drive the expansion rubber plug into

the hole.

3. Take out the camera in the packaging box, remove the dome cover, and fasten the dome to the

ceiling with screws.

4. Loosen the adjusting screw, adjust the camera lens to an appropriate angle, and then re-fasten the

adjusting screw.

5. Align the dome cover with the mounting position of the base, and then rotate and fasten it.

Note: The mounting surface of camera must have sufficient bearing capacity.

27