Текст страницы
Electrical connection
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• Loosen the screws on the appliance back and re-
• The accessibility of the power plug must be en-
move the appliance cover.
sured to disconnect the appliance from the power
• Dismount the upper door hinge and the screws
supply in case of emergency.
(s). Lift the appliance door and set it safely aside.
• Make sure that the voltage supply matches the
• Tilt the appliance slightly backwards and block it
specifications on the rating label before connect-
in this position. Unscrew the feet and disassemble
ing.
the lower door hinge.
• Connect the mains cable to a properly installed
• Transfer and attach the lower door hinge to the
and earthed wall outlet.
opposite appliance side. Screw in the feet accord-
• If the plug after installation is not accessible, a
ingly.
corresponding disconnect device must be availa-
• Put the appliance back in the upright position.
ble to meet the relevant safety regulations.
Put on the appliance door and fix it its intended
position.
Reversing the door opening
• Transfer and attach the upper door hinge to the
If required, the door opening can be moved from the
opposite appliance side after unscrewing the
right (supplied condition) to the left side.
hinge pin and inserting it into the adjacent hole.
WARNING:
Screw in the screws (s) on the opposite side.
When replacing the door stop, the appliance must be
• Replace the appliance cover and fix it.
disconnected from the power supply first.
• Dismount the door handle and attach it to the cor-
NOTE:
responding other door outer side. Refer to the in-
• Ask another person to assist.
structions in "Assembling the door handle". Trans-
• You possibly need: screw wrench, Phillips screw-
fer the cover caps on the exposed holes to the re-
driver as well as a thin-blade screwdriver.
spective other door outer side.
Check that the door is optimally aligned both verti-
cally and horizontally to ensure smooth opening and
closing of the door.
20