Текст страницы
• Then you can put the appliance back into opera-
tion by connecting it to the power supply and ad-
justing the temperature control.
Replacing the door hinge
• The door handle is mounted in the reverse se-
If the appliance door starts to stutter, crack or jam
quence, see also “Assembling the door handle”.
when you open it, it is probably due to a worn or
damaged hinge.
Troubleshooting
It is recommended to replace all door hinges at the
same time, otherwise the next repair will soon be
Before you contact an authorized specialist
beckoning.
Problem / Cause / Action
• Remove the contents of the appliance and the
Appliance is not working properly or at all
movable interior parts.
- Check the power supply / temperature setting /
• Tilt the appliance backwards and block it in this
ambient temperature.
position to prevent the door from sliding out.
- Unblock the ventilation openings, install the ap-
pliance freely.
Loading is too warm
- Check the temperature setting / ambient temper-
ature.
- A large quantity of warm food has been stored in
• Loosen the appliance cover as described under
the unit in the last 24 hours.
“Reversing the door opening” and disassemble
- The appliance door is not closed properly, check
the upper door hinge.
the door seal.
• Turn out the stand and disassemble the lower
Loud noise during operation
door hinge.
- Check that the appliance is level.
• The respective hinge assembly is carried out in
- See "Operating noise".
reverse order.
Water on the appliance bottom
• Open and close the appliance door for a test run,
- Check the temperature setting.
readjust the hinges if necessary. In any case,
make sure that the door fits tightly and accurately.
NOTE:
If a problem persists after following the steps above,
Replacing the door handle
contact your trader or an authorized technician.
A malfunction due to too active use, may cause dam-
age to the door handle.
• Loosen the screw cover caps.
• Unscrew the screws underneath and remove the
door handle.
25