Текст страницы
Tilt the vacuum body backward, press
4.When the water tank comes into
the power switch, and push the vacuum
contact with the ground, the water in the
cleaner forward and backward to make
water tank will drip through the water
it start working; press the power switch
dispenser hole to wet the mop.
again to make it stop working.
5.After startup, the vacuum cleaner starts
cleaning operation of vacuuming
together with mopping.
6. Remove the water tank after use, open
Used as a handheld vacuum
cleaner
the water tank plug, pour out the
As required, the vacuum body can be
remaining water, and then close the
connected with a crevice nozzle, wide
plug.
combination tool, illumination multi-
Fig. D1-D6
surface brush, and motorized mini-brush
used as a handheld vacuum cleaner.
Prompts
It is not allowed to fill corrosive liquid
into the water tank.
The vacuum cleaner is not allowed to
Startup for use
be used in ponding areas; do not
The energy-saving mode is as default for
inhale water into the vacuum cleaner,
startup. Press “+”“-”on the display
otherwise the machine will be
screen for gear speed regulation. There
damaged.
are 3 gear speed regulation modes.
Open the water inlet soon after use and
pour out the remaining water to avoid
Prompts
water seepage from damaging the floor
During operation, the display screen
or furniture.
shows the current battery level and
Remove the mop and then dry it after
current gear level. When the battery level
use to prevent odor and facilitate the
is lower than 20, please charge in time.
next use.
Illumination multi-surface brush
While the illumination multi-surface
Use of different accessories
brush is working, the LED light at the
Water tank assembly
front end is turned on, facilitating its use
1.Dampen the mop pad and wring out
in a dark environment.
excess water, then attach it securely to
the bottom of the water tank.
Prompts
2.Open the water tank plug, add an
When used for auxiliary dust
appropriate amount of clean water, then
vacuuming, the illumination multi-
close the plug.
surface brush constantly rotates at high
speed, so that please do not stay at a
3.Align the water tank with the bottom of
same place for too long, otherwise the
the illumination multi-surface brush, and
floor surface may be damaged.
then clip it in, ensuring the water tank is
There is an over current protection
in place.
4