Текст страницы
clean water until it is clean.
After cleaning, dry it by air for at least
4.Stand the brush roller upright for at least
24 hours.
24 hours until it is dry completely.
Fig.E1-E4
Fig.E11-E14
Attention: Please clean the dust cup as
required.
Cleaning motorized mini-brush
It is recommended to clean the cyclone
system and air inlet filter at least once
every 3-4 months.
1. Use a coin to turn the lock
counterclockwise until you hear click,
then pull out the roller brush.
2. Use scissors to cut and pick out any
hair or other debris tangled around the
roller brush. Wipe the slot and
transparent cover with dry cloth or tissue.
Installation of dust cup, air inlet
filter, and cyclone separator
assembly
1.Put the inlet filter back into the cyclone
separator.
3.When it is dirty, rinse the roller with
clean water until it is clean.
4.Stand the roller upright for at least 24
hours until it is completely dry.
Fig.E15-E19
2.Hold the cyclone separator, and rotate
it counterclockwise onto the vacuum
cleaner.
3.Align the dust cup with the slot on the
vacuum cleaner, and rotate it slowly
until the dust cup clicks into place.
Fig.E5-E7
Cleaning water tank (with mop
pad)
Remove the mop pad from the bottom of
Cleaning air outlet filter
the water tank, and rinse it with water or
1.Open the cover plate of air outlet filter
using a washing machine. Leave it to air
2.Take out the air outlet filter
dry before use.
3.Rinse the air outlet filter with clean
Fig.E20-E21
water, and after it is cleaned, dry it by
air for at least 24 hours.
Fig.E8-E10
Cleaning illumination
multi-surface brush
1.Toggle the lock knob of the roller brush
in the arrow direction and lift the roller
pressing plate at the same time, and
then take out the roller brush.
2.Cut off the hair and fiber adhering to the
brush roller with scissors, and wipe up
the dust from the groove and transparent
cover with dry cloth or tissue. Wipe it up
completely before use.
3.Rinse the brush roller, if it is dirty, with
6