Текст страницы
Installation and connection en
1. Connect the water inlet hose.
away quickly and eliminate any
blockages.
Note: Observe the draining heights.
The maximum draining height is
100 cm.
Siphon
Secure the con-
nection point with
a (24–40 mm)
hose clamp.
2. Connect the water inlet hose to a
tap (26.4 mm = 3/4").
Sink
Fix and secure the
water outlet hose
with an elbow.
"Accessories",
Page 25
Plastic pipe with
rubber sleeve or
gully
Fix and secure the
water outlet hose
with an elbow.
"Accessories",
Page 25
3. Open the water tap carefully and
check that the connection points
are tight.
Water outlet connection types
This information is intended to help
you to connect this appliance to the
water outlet.
Connecting the appliance to the
electricity supply
Note: Your electrical domestic install-
ation for this appliance must comply
with the local legal provisions and
safety regulations, and should in-
clude a residual current circuit-
breaker.
1. Insert the mains plug of the appli-
ATTENTION
When draining, the water outlet hose
is subject to water pressure and may
come loose from the installed con-
nection point.
Secure the water outlet hose
against unintentional loosening.
In the event of a blocked or covered
outlet, accumulated wastewater can
flow back into the appliance.
ance's power cable in a socket
nearby.
The connection details of the appli-
ance can be found under Tech-
nical data
Page 43.
2. Check the mains plug is inserted
properly.
Before operating the appliance, en-
sure that the wastewater drains
13