Текст страницы
24 | English
Max. [mm]
[mm]
D
b
s
d
α
[min-1] [m/s]
125
7.2
–
X-LOCK
–
11,000
80
125
4.2
–
X-LOCK
–
11,000
80
125
–
–
X-LOCK
–
11,000
80
75
30
–
X-LOCK
–
11,000
45
125
24
–
X-LOCK
–
11,000
80
125
–
–
X-LOCK
–
11,000
80
83
–
–
X-LOCK
–
11,000
80
(3)
u After fitting, check that the edge of the abrasive tool
125
6
10
X-LOCK
> 0
11,000
80
s
α
Rotating the machine head (see figure E)
(➍) is fitted correctly, i.e. is no higher than the refer-
ence surface (➎). If the edge is higher than the refer-
ence surface, either the holder must be cleaned or the
abrasive tool must not be used.
Before removing the grinding/cutting/flap disc: Make
sure that the power tool has come to a complete stop.
u Pull the plug out of the socket before carrying out any
Removing the abrasive tool
➊Open the lever (3).
➋The grinding/cutting/flap disc will be released.
➌The grinding/cutting/flap disc can be removed.
work on the power tool.
The machine head can be rotated in 90° increments. In this
way, the on/off switch can be brought into a more favourable
handling position for particular applications, e.g. for left-
handed tool users.
Completely unscrew the four screws (➊). Rotate the ma-
chine head carefully, without removing it from the hous-
ing, into the new position (➋). Screw in and retighten the
four screws (➌).
Dust/Chip Extraction
(3)
(3)
Approved abrasive tools
The dust from materials such as lead paint, some types of
wood, minerals and metal can be harmful to human health.
Touching or breathing in this dust can trigger allergic reac-
tions and/or cause respiratory illnesses in the user or in
people in the near vicinity.
Certain dusts, such as oak or beech dust, are classified as
carcinogenic, especially in conjunction with wood treatment
additives (chromate, wood preservative). Materials contain-
ing asbestos may only be machined by specialists.
– Use a dust extraction system that is suitable for the ma-
You can use all the abrasive tools mentioned in these operat-
ing instructions.
The permissible speed [min-1] or the circumferential speed
[m/s] of the abrasive tools used must at least match the val-
ues given in the table.
It is therefore important to observe the permissible rota-
tional/circumferential speed on the label of the abrasive
tool.
terial wherever possible.
– Provide good ventilation at the workplace.
– It is advisable to wear a P2 filter class breathing mask.
The regulations on the material being machined that apply in
the country of use must be observed.
1 609 92A 765 | (17.03.2022)
Bosch Power Tools