Текст страницы
•
Seal the cut surfaces with a sealant to
prevent moisture from causing swelling.
•
Protect the bottom of the appliance from
steam and moisture.
•
Do not install the appliance next to a door
or under a window. This prevents hot
cookware from falling from the appliance
when the door or the window is opened.
•
Each appliance has cooling fans on the
bottom.
•
If the appliance is installed above a
drawer:
–
Do not store any small pieces or
sheets of paper that could be pulled
in, as they can damage the cooling
fans or impair the cooling system.
–
Keep a distance of minimum 2 cm
between the bottom of the appliance
and parts stored in the drawer.
•
Remove any separator panels installed in
the cabinet below the appliance.
2.2 Electrical Connection
•
Make sure not to cause damage to the
mains plug (if applicable) or to the mains
cable. Contact our Authorised Service
Centre or an electrician to change a
damaged mains cable.
•
The shock protection of live and insulated
parts must be fastened in such a way that
it cannot be removed without tools.
•
Connect the mains plug to the mains
socket only at the end of the installation.
Make sure that there is access to the
mains plug after the installation.
•
If the mains socket is loose, do not
connect the mains plug.
•
Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
•
Use only correct isolation devices: line
protecting cut-outs, fuses (screw type
fuses removed from the holder), earth
leakage trips and contactors.
•
The electrical installation must have an
isolation device which lets you disconnect
the appliance from the mains at all poles.
The isolation device must have a contact
opening width of minimum 3 mm.
WARNING!
Risk of fire and electric shock.
2.3 Use
WARNING!
Risk of injury, burns and electric
shock.
•
All electrical connections should be made
by a qualified electrician.
•
The appliance must be earthed.
•
Before carrying out any operation make
sure that the appliance is disconnected
from the power supply.
•
Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
•
Make sure the appliance is installed
correctly. Loose and incorrect electricity
mains cable or plug (if applicable) can
make the terminal become too hot.
•
Use the correct electricity mains cable.
•
Do not let the electricity mains cable
tangle.
•
Make sure that a shock protection is
installed.
•
Use the strain relief clamp on the cable.
•
Make sure the mains cable or plug (if
applicable) does not touch the hot
appliance or hot cookware, when you
connect the appliance to the near sockets.
•
Do not use multi-plug adapters and
extension cables.
•
Remove all the packaging, labelling and
protective film (if applicable) before first
use.
•
This appliance is for household (indoors)
use only.
•
Do not change the specification of this
appliance.
•
Make sure that the ventilation openings
are not blocked.
•
Do not let the appliance stay unattended
during operation.
•
Set the cooking zone to “off” after each
use.
•
Do not rely on the pan detector.
•
Do not put cutlery or saucepan lids on the
cooking zones. They can become hot.
•
Do not operate the appliance with wet
hands or when it has contact with water.
•
Do not use the appliance as a work
surface or as a storage surface.
•
If the surface of the appliance is cracked,
disconnect immediately the appliance
ENGLISH
5