Инструкция компьютерное кресло Evolution LX 2

ON OFF

PART 7: OPTION JUMPERS AND CABLING
OPTION JUMPER DESCRIPTIONS
Factory default for all jumper settings is in the ON position. To remove a jumper
in the OFF position place the jumper on a single pin for future use
VSEL J7
This jumper when in the ON position supplies a +12vdc source on the RJ50 input
connector. The hand held controller uses this source for power. Removing this
jumper prevents the +12vdc source from exiting on pin 2 and possibly damaging
other external control devices.
PDEN J8
This jumper when in the ON position the internal product detect is passed to the
processor. Removing this jumper inhibits the internal product detect.
ENSEL J9
When this jumper is in the ON position the external encoder signal connected to
the RJ50 output connector is passed through the printer to the RJ50 input
connector. This allows the same encoder signal to drive several printers. If this is
not desired remove the jumper
PRSEL J10
When this jumper is in the ON position the external product detect signal
connected to the RJ50 output connector is passed through the printer to the
RJ50 input connector. This allows the same product detect signal to drive several
printers. If this is not desired remove the jumper

1
EVOLUTION LX SYSTEM MANUAL Issue 1.0 5 DEC 2009