Инструкция компьютерное кресло Evolution LX 2

ERASE STORED MESSAGES YES OR NO Y/N

RESET PRINT HEAD YES OR NO Y/N

ALL HEADS
WILL BE RESET
CONTINUE = X KEY
ANY OTHER EXITS

SYSTEM RESET
Soft Reset
There are two types of resets available in the Evolution printing system. The first
type of reset is a SOFT RESET.
Remove the cable between the controller and print
station.
Pressing the R key while reconnecting the cable to
the controller will display the reset screen.
CAUTION: A response of Y will delete all stored
messages from the controller.
The next screen to appear prompts the user to
determine if a print head is to be restored to its
default value.
CAUTION: ALL PRINT HEADS CONNECTED
TO THE CONTROLLER WILL BE RESET TO
FACTORY
DEFAULT
CONDITIONS.
THIS
INCLUDES RESETTING EACH UNIT ADDRESS
TO 1. TO PREVENT THIS REMOVE ALL
INTERCONNECTED PRINT HEADS EXCEPT
FOR THE UNIT TO BE RESET FROM THE
DATA LINK.
The specific unit address must be reset to the correct value after
a reset.
Hard Reset
The second reset is a hard reset. Disconnect the power cable. Insert a standard
paper clip into the hole on the female dovetail side of the cabinet, and while
holding the paper clip in place (a light click will be felt) re-apply the power
connector. Keep the reset switch depressed for at least 5 seconds.
This operation will reset the printer to the factory default settings and clear any
current message.
NOTE: FOR BOTH A SOFT AND HARD RESET THE DISPLAY
WILL
SHOW
THE
DEFAULT
MESSAGE:
“EVOLUTION”

8
EVOLUTION LX SYSTEM MANUAL Issue 1.0 5 DEC 2009