Текст страницы
en Troubleshooting
Repairs to the appliance should only be carried out by trained specialist
staff.
Only use genuine spare parts when repairing the appliance.
If the power cord of this appliance is damaged, it must be replaced by the
manufacturer, the manufacturer's Customer Service or a similarly qualified
person in order to prevent any risk.
Energy-saving mode is active
Press
Start/Reload.
Fault
Cause and troubleshooting
The display goes out
and (
Start/Re-
load) flashes.
The water outlet hose is connected too high, is kinked
or trapped, or has been extended impermissibly.
Check the installation of the water outlet hose.
E:36 -10 / E:30 -80
The detergent solution
is not being pumped
out.
Page 12
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
The drain pump is blocked or the pump cover is not in-
stalled correctly.
Check that the pump cover is installed correctly.
Page 33
Clean the drain pump.
Page 33
Detergent dosage is too high.
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
E:36 -25 -26
Drain pump is blocked.
Clean the drain pump.
Page 33
H:32
The appliance has interrupted the spin cycle because
the laundry is unevenly distributed.
Redistribute the laundry in the drum.
E:30 -10 /
The tap is turned off.
Turn on the tap.
The water inlet hose is kinked or jammed.
Check the installation of the water inlet hose.
Page 12
The filters in the water inflow are blocked.
Clean the filters in the water inflow.
Scan the QR code to see an animation of the process.
36