Инструкция принтер лазерный Катюша P130

1.2.2 Error Causes and Solution

Error Code (205000)
Initial fail, system can not find printer within 30 seconds after turning on.
< User Check >
(1) Turn off and then on the printer.

Step
Cause
Solution

1
Can not find the printer.
Restart the printer.

2
Main board malfunctioned.
Replace the main board..


Error Code (201610)
Restart the device. Error in LPH. LPH FFC cable may not install well or is damaged.
< User Check >
(1)Restart printer.

Step
Cause
Solution

1
LPH activation abnormal
Reassemble LPH FFC or replace LPH
FFC.

Error Code (205101)
eEngError_HiVChargerError：Image error caused by abnormal charge of the drum unit.
< User Check >
(1) Slide the green tab of the drum unit to and fro for 2 or 3 times to clean the corona wire.
(2) Clean several contact points of the drum unit.
(3) Replace a drum unit.

Step
Cause
Solution

1
Corona wire contaminated.
Clean corona wire.

2
Corona wire broken
Replace drum unit.

3
Power Supply Board hit by
strong current
Replace the Power Supply Board.


Paper Jam Error (200301)
Printer Paper Jam(01)：Load paper from manual tray but fails to pick paper.
< User Check >
(1) Check if paper is correctly loaded into the manual tray.
(2) Open front cover and remove the drum unit to remove paper.
(3) Check if the paper has been removed.

Step
Cause
Solution

1
Dirt on pickup roller
Clean the pickup roller. Refer to the
drawing below.
2
Feeding rollers and
separation pad contaminated.
Regularly clean pad and rollers.

3
IFA99 Cable not connect well Connect IFA99 cable correctly.

4
Pickup roller clutch failed.
Replace clutch.

5
IF98 board defective
Replace the IF98 board.

6
Main board defective
Replace the main board..
 Pre-check: Check paper path and sensors (Refer to Sensor Setting information check).

<Cleaning the pickup roller>

Confidential
11