Текст страницы
en Troubleshooting
Fault
Cause and troubleshooting
High spin speed not
reached.
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶Start the Spin programme.
The spin programme
does not start.
Drain pipe or water outlet hose is blocked.
▶Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶Ensure that the drain pipe and water drain hose are
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶Redistribute the laundry in the drum.
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶Start the Spin programme.
Rushing, hissing
noise.
Water is flushed under pressure into the detergent
drawer.
▶Not a fault – normal operating noise.
Loud noises during
the spin cycle.
Appliance is not correctly aligned.
▶→ "Aligning the appliance", Page 16
The appliance feet are not fixed.
▶Secure the appliance feet.
→ "Aligning the appliance", Page 16
Transit bolts have not been removed.
▶→ "Removing the transit bolts", Page 13.
Foreign bodies have got into the drain pump.
▶→ "Cleaning the drain pump", Page 31.
Banging noises, rat-
tling in the drain
pump.
Slurping, rhythmical
suction noise.
The drain pump is active, the detergent solution is
pumped out.
▶Not a fault – normal operating noise.
Creasing.
The spin speed is too high.
▶The next time you run a wash cycle, set a lower
spin speed.
The load is too large.
▶The next time you run a wash cycle, reduce the
amount of laundry being loaded.
40