Текст страницы
Channel Width
Select the channel width of the AP. The available options differ among
different APs.
We recommend you set the channel bandwidth to Auto to improve the
transmission speed. However, you may choose a lower bandwidth due to
the following reasons:
• To increase the available number of channels within the limited total
bandwidth.
• To avoid interference from overlapping channels occupied by other
devices in the environment.
• Lower bandwidth can concentrate higher transmit power, increasing
stability of wireless links over long distances.
Channel Limit
Check the box to enable the Channel Limit function. With this function
enabled, the wireless frequency 5150MHz~5350MHz will be disabled. This
function can influence the available options in Channel.
This feature is only available on certain devices. To check whether your
device supports this feature, refer to the actual web interface.
Channel
Select the channel used by the EAP. For example, 1/2412MHz means that
the channel is 1 and the frequency is 2412MHz.
By default, the channel is automatically selected, and we recommend that
you keep the default setting.
Tx Power (EIRP)
Specify the transmit power value.
If this value is set to be larger than the maximum transmit power that is
allowed by the local regulation, the regulated maximum transmit power will
be applied in the actual situation.
Note: In most cases, it is unnecessary to use the maximum transmit power.
Specifying a larger transmit power than needed may cause interference to
the neighborhood. Also it consumes more power and reduces longevity of
the device.
Load Balance
With the Load Balance feature, you can limit the maximum number of clients who can
access the EAP. In this way, you can achieve rational use of network resources.
28