Текст страницы
6.4 Configure Web Server
With the web server, you can log in to the management web page of the EAP. You can
configure the web server parameters of the EAP according to your needs.
To configure Web Server, go to the Management > Web Server page.
Follow the steps below to configure Web Server:
1. Refer to the following table to configure the parameters:
Secure Server Port
Designate a secure server port for web server in HTTPS mode. By
default the port is 443.
Server Port
Designate a server port for web server in HTTP mode. By default the
port is 80.
Session Timeout
Set the session timeout. If you do nothing with the web page within
the timeout, the system will log out automatically. You can log in again
if you want to go back to web page.
Layer-3
Accessibility
With this feature enabled, devices from a different subnet can access
Omada managed devices via the management web page. With this
feature disabled, only the devices in the same subnet can access
Omada managed devices via the management web page.
TLS Version
1.0/1.1
The EAP management page uses TLS v1.2 by default. You can enable
the feature if you prefer TLS v1.0/1.1.
This feature is only available on certain devices. To check whether
your device supports this feature, refer to the actual web interface.
2. Click Save.
90