Текст страницы
For network stability, you can also configure the fallback IP parameters for the EAP:
Fallback IP
With the fallback IP configured, if the EAP fails to get an IP
address from a DHCP server within 10 seconds, the fallback
IP will work as the IP address of the EAP. After that, however,
the EAP will keep trying to obtain an IP address from the DHCP
server until it succeeds.
DHCP Fallback IP
Specify a fallback IP address for the EAP. Make sure that this IP
address is not being used by any other device in the same LAN.
The default DHCP fallback IP is 192.168.0.254.
DHCP Fallback IP MASK
Specify the network mask of the fallback IP. The default DHCP
fallback IP mask is 255.255.255.0.
DHCP Fallback Gateway
Specify the network gateway.
• Static
If you choose Static as the IP address mode, you need to manually specify an IP
address and the related network parameters for the EAP. Make sure that the specified
IP address is not being used by any other device in the same LAN.
Configure the IP address and network parameters as the following table shows:
IP Address
Specify a static IP address for the EAP.
IP Mask
Specify the network mask.
Gateway
Specify the network gateway.
Primary DNS
Specify the primary DNS server.
Secondary DNS
Specify the secondary DNS server. (Optional)
3. Click Save.
86